On ZTE's PTN products, command()is used to check whether boot version supports on
line upgrade or not.
line upgrade or not.
A.show ip config
B.show ip interface brief
C.show interface ip brief
D.show ip config all
A.The load sharing protection mode can be classified into return mode and non-return mode.
B.Master/slave LAG protection mode can be classified into return mode and non-return mode.
C.The LAG aggregation mode of ZTE equipment can be classified into dynamic mode and static mode.
D.Currently, the 6300 equipment does not support master/slave LAG at NNI side.
A.2.40 T bit/s
B.3.20 T bit/s
C.1.80 T bit/s
D.5.60 T bit/s
A.Stress factors.
B.Man-hours.
C.Machine tolerances.
D.Customer-appeal.
(ii) Explain how the existing product range and the actions per Note (3) would feature in Ansoff’s
product-market matrix. (7 marks)
met to discuss how the company might respond to a number of problems that have arisen with Product 2. After a
number of incidents in which Product 2 had failed whilst being used by customers, Chen Products had been presented
with compensation claims from customers injured and inconvenienced by the product failure. It was decided that the
risk committee should meet to discuss the options.
When the discussion of Product 2 began, committee chairman Anne Ricardo reminded her colleagues that, apart from
the compensation claims, Product 2 was a highly profitable product.
Chen’s risk management committee comprised four non-executive directors who each had different backgrounds and
areas of expertise. None of them had direct experience of Chen’s industry or products. It was noted that it was
common for them to disagree among themselves as to how risks should be managed and that in some situations,
each member proposed a quite different strategy to manage a given risk. This was the case when they discussed
which risk management strategy to adopt with regard to Product 2.
Required:
(a) Describe the typical roles of a risk management committee. (6 marks)
Which of the following statements describes target costing?
A.It calculates the expected cost of a product and then adds a margin to it to arrive at the target selling price
B.It allocates overhead costs to products by collecting the costs into pools and sharing them out according to each product’s usage of the cost driving activity
C.It identifies the market price of a product and then subtracts a desired profit margin to arrive at the target cost
D.It identifies different markets for a product and then sells that same product at different prices in each market
A.To display current alarm of device correctly, the device needs to report current alarm to EMS actively. Therefore, necessary configuration for the device to actively report alarms must be correctly set.
B. Protection switching event alarm occurs at the instant when protection group switching happens, so it is not durative alarm. Therefore, after the alarm occurs, it is immediately saved in locking alarm. You can check it only in the locking alarms.
C. If EMS server timezone is different from PTN device timezone, alarm occurrence time on PTN device will be different from that on EMS. Therefore, during commissioning of PTN, you should set PTN timezone to be consistent with EMS timezone, usually local timezone.
D. None of the above